|
|
|||||||||
|
Persons using assistive technology might not be able to fully access information in this file. For assistance, please send e-mail to: mmwrq@cdc.gov. Type 508 Accommodation and the title of the report in the subject line of e-mail. Silicosis Among Pottery Workers -- New JerseyIn March 1985, two cases of silicosis in former employees of a sanitary-ware pottery (i.e., a manufacturer of china plumbing fixtures) were identified from death certificates by the New Jersey State Department of Health (NJSDH). A site visit to the pottery in January 1987 revealed potential overexposure of employees to crystalline silica throughout the plant. This report summarizes the investigation of employee exposure to silica. During June 1988, CDC's National Institute for Occupational Safety and Health (NIOSH) and the NJSDH conducted a joint study at this facility to assess both crystalline silica exposures and the adequacy of control measures (1). Forty-seven percent of personal breathing-zone samples exceeded the Occupational Safety and Health Administration's (OSHA) permissible exposure limit (PEL) of 100 ug/m3 for crystalline silica; 53% exceeded the NIOSH recommended exposure limit (REL) of 50 ug/m3. Based on these findings, specific engineering controls and work practices were recommended to reduce exposures and prevent additional cases of silicosis. During October 1988, NJSDH conducted an on-site medical screening of all 120 pottery employees and obtained employee medical and work histories, chest radiographs, and spirometry. The radiographs were evaluated by three NIOSH-certified "B" readers * (2). Radiographs of five (4%) current employees who were not previously known to have pneumoconiosis had readings of 1/0 or greater, generally regarded as positive for pneumoconiosis (3). Based on these findings, the company agreed to institute a surveillance program to continue medical monitoring of all plant employees. During October 1988, a follow-up environmental survey by NJSDH to assess the extent of compliance with the recommended controls and work practices determined that, although the company had implemented many of these recommendations, some problems persisted. For example, respirator use remained sporadic despite documentation of substantial exposures to crystalline silica dust throughout the plant. NJSDH recommended that a comprehensive respirator program be vigorously enforced until these exposure levels are reduced below the NIOSH REL through appropriate engineering controls and work practices. Reported by: D Valiante, MS, P Bost, MS, M Stanbury, MS, J Szenics, MD, Occupational Health Svc, New Jersey State Dept of Health. Div of Physical Sciences and Engineering, National Institute for Occupational Safety and Health, CDC. Editorial NoteEditorial Note: Since 1984, the NJSDH has conducted surveillance of silicosis under several NIOSH Capacity Building Programs (4). This surveillance system uses both morbidity (i.e., hospital discharge) and mortality (i.e., death certificate) data to identify cases of silicosis. In addition, NJSDH participates in the Sentinel Event Notification System for Occupational Risks (SENSOR) program for surveillance of occupational asthma and silicosis, which includes physician reporting of cases of silicosis and combines surveillance with retrospective investigation (5). In conjunction with the SENSOR program, NIOSH has published surveillance guidelines for state health departments to use in promoting physicians' recognition and reporting of silicosis (6). The sanitary-ware pottery industry is classified under standard industrial classification (SIC) 3261 -- vitreous china plumbing fixtures and china and earthenware fittings and bathroom accessories. In the United States, 34 manufacturing facilities have a primary SIC of 3261 (7); located in 14 states, half are concentrated in three states -- California, Ohio, and Texas. ** Of an estimated 6400 persons employed in this industry, approximately 4300 have occupational exposure to crystalline silica (NIOSH, unpublished data, 1991). In New Jersey, the predominant industries in which persons with silicosis have worked include sand and gravel mines, foundries, and ceramics (both china and sanitary ware). Persons with silicosis are at substantially increased risk for other pulmonary diseases, particularly tuberculosis, bronchitis, and emphysema (8). In the United States, each year approximately 250 workers are reported with (9) and 135 die from silicosis (10). The investigation described in this report underscores the potential health hazards associated with the use of crystalline silica in manufacturing sanitary ware. Assessments of similar facilities have detected the same problems and conditions (i.e., use of raw materials high in crystalline silica content, poor or inadequate ventilation to control dust sources, poor housekeeping practices, and lack of effective respiratory-protection programs for workers). Full implementation of recommended control measures should reduce the risk for silicosis among workers in this industry. References
Disclaimer All MMWR HTML documents published before January 1993 are electronic conversions from ASCII text into HTML. This conversion may have resulted in character translation or format errors in the HTML version. Users should not rely on this HTML document, but are referred to the original MMWR paper copy for the official text, figures, and tables. An original paper copy of this issue can be obtained from the Superintendent of Documents, U.S. Government Printing Office (GPO), Washington, DC 20402-9371; telephone: (202) 512-1800. Contact GPO for current prices. **Questions or messages regarding errors in formatting should be addressed to mmwrq@cdc.gov.Page converted: 08/05/98 |
|||||||||
This page last reviewed 5/2/01
|